ENGINE SWITCH INSPECTION

PROCEDURE

  1. INSPECT ENGINE SWITCH

    1. A295732C01

      *a

      Component without harness connected

      (Engine Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      5 (SS1) - 6 (AGND)

      1 (SS2) - 6 (AGND)

      Not pushed

      10 kΩ or higher

      5 (SS1) - 6 (AGND)

      1 (SS2) - 6 (AGND)

      Pushed

      Below 1 Ω

      If the result is not as specified, replace the engine switch.

    2. Apply battery voltage between the terminals of the engine switch, and check the illumination condition of the engine switch.

      OK

      Measurement Condition

      Specified Condition

      Battery positive (+) → Terminal 9 (SWIL)

      Battery negative (-) → Terminal 6(AGND)

      Illuminates
      Note:

      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.

      • If the voltage is too low, the indicator will not illuminate.

      If the result is not as specified, replace the engine switch.