DIFFERENTIAL OIL ADJUSTMENT


  1. INSPECT AND ADJUST DIFFERENTIAL OIL


    1. Stop the vehicle on a level place.

    2. Remove the differential filler plug and gasket.

    3. B007P4BE04

      Check that the oil surface is within 5 mm (0.20 in.) of the lowest position of the inner surface of the differential filler plug opening.

      Note


      • Excessively large or small amounts of oil may cause trouble.

      • After replacing oil, drive the vehicle and check the oil level.

      Tech Tips

      If necessary, fill the rear differential carrier with hypoid gear oil.

    4. Check for oil leakage when the oil level is low.

    5. Install the differential filler plug and a new gasket.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }

  2. FILL DIFFERENTIAL OIL


    1. Remove the differential filler plug and gasket.

    2. Fill with oil.

      Oil grade
      Toyota Genuine Differential Gear oil GL-5 or equivalent
      Recommended oil viscosity
      Above -18°C (0°F) SAE 90
      Below -18°C (0°F) SAE 80W or 80W-90
      Standard differential oil capacity
      Body Type Specified Condition
      Standard Body 3.10 liters (3.28 US qts, 2.73 Imp. qts)
      Wide Body 3.25 liters (3.43 US qts, 2.86 Imp. qts)

    3. Check the oil level.

    4. Install the differential filler plug with a new gasket.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }

      Note

      After replacing the oil, recheck the oil level after driving.