DYNAMIC RADAR CRUISE CONTROL SYSTEM Millimeter Wave Radar Sensor Power Source Circuit

DESCRIPTION

When the engine switch is turned on (IG), battery voltage is applied to terminal IGB of the millimeter wave radar sensor assembly.

This circuit provides power to the millimeter wave radar sensor assembly. The millimeter wave radar sensor assembly emits radio waves towards an object in front and measures the distance and direction of the object by receiving the beam reflections. Based on the reflections, the sensor calculates the difference in speed between the vehicle and the object in front. This data is transmitted to the driving support ECU assembly.

WIRING DIAGRAM

B0058RXE10
w/o Stop and Start System
*a from IG1-NO.1 Relay
*b ECU-IG NO.3
*c Millimeter Wave Radar Sensor Assembly
B005A0BE04
w/ Stop and Start System
*a from Engine Stop and Start ECU
*b Millimeter Wave Radar Sensor Assembly

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MILLIMETER WAVE RADAR SENSOR ASSEMBLY - BATTERY AND BODY GROUND)


    1. B005ANLC60
      *a

      Front view of wire harness connector

      (to Millimeter Wave Radar Sensor Assembly)

      Disconnect the millimeter wave radar sensor assembly connector.

    2. Measure the voltage and resistance according to the value(s) in the table below.

      Standard Voltage
      w/o Stop and Start System
      Tester Connection Switch Condition Specified Condition
      A21-5 (IGB) - Body ground Engine switch on (IG) 11 to 14 V
      A21-5 (IGB) - Body ground Engine switch off Below 1 V
      w/ Stop and Start System
      Tester Connection Switch Condition Specified Condition
      A21-5 (IGB) - Body ground Engine switch on (IG) 10.5 to 16 V
      A21-5 (IGB) - Body ground Engine switch off Below 1 V
      Standard Resistance
      Tester Connection Condition Specified Condition
      A21-1 (SGND) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR