RADIO ANTENNA CORD (for Glass Antenna Type) INSTALLATION

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL NO. 4 ROOF WIRE (NO. 2 ANTENNA CORD SUB-ASSEMBLY) (w/ Rear View Monitor System)


    1. Attach the guide and each clamp to install the No. 4 roof wire (No. 2 antenna cord sub-assembly).

    2. Connect each connector.

    3. Install the bolt.

  2. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Rear View Monitor System)


    1. Attach the guide and each clamp to install the No. 2 antenna cord sub-assembly.

    2. Connect each connector.

    3. Install the bolt.

  3. INSTALL ROOF HEADLINING

    Click here

  4. INSTALL INSTRUMENT PANEL ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  6. CHECK SRS WARNING LIGHT (w/ Airbag System)

    Click here