ENGINE UNIT COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
| *A | for Type A | *B | for Type B |
| *C | for Oil Filter Element Kit Type | *D | for Oil Filter Sub-assembly Type |
| *1 | ENGINE MOUNTING BRACKET RH | *2 | TIMING CHAIN COVER SUB-ASSEMBLY |
| *3 | NO. 1 CHAIN TENSIONER ASSEMBLY | *4 | ENGINE OIL PRESSURE SWITCH ASSEMBLY |
| *5 | OIL FILTER BRACKET | *6 | OIL FILTER ELEMENT |
| *7 | OIL FILTER CAP ASSEMBLY | *8 | CRANKSHAFT PULLEY |
| *9 | TIMING CHAIN COVER OIL SEAL | *10 | ENGINE WATER PUMP ASSEMBLY |
| *11 | INLET WATER SUB-ASSEMBLY | *12 | BRACKET |
| *13 | GASKET | *14 | SEAL WASHER |
| *15 | O-RING | *16 | OIL FILTER SUB-ASSEMBLY |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
MP grease | ★ | Precoated part |
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
| *A | Type A | *B | Type B |
| *1 | NO. 1 TAPER SCREW PLUG | *2 | REAR ENGINE OIL SEAL |
| *3 | VENTILATION VALVE SUB-ASSEMBLY | *4 | KNOCK SENSOR |
| *5 | STIFFENING CRANKCASE ASSEMBLY | *6 | OIL PUMP ASSEMBLY |
| *7 | NO. 2 OIL PAN SUB-ASSEMBLY | *8 | OIL PAN DRAIN PLUG |
| *9 | GASKET | *10 | RING PIN |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
MP grease |  |
Adhesive 1324 |
 |
Adhesive 1344 | - | - |