FAN REMOVAL


  1. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD)

    A01DWKI

    1. Remove the 8 bolts and under cover.

  2. DRAIN ENGINE COOLANT

    Note

    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. A01DWSH

      Remove the reservoir cap and, using a wrench, remove the vent plug.

    2. Loosen the cylinder block drain cock plug and the radiator drain cock plug and then drain the coolant.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

      A01DZFLE01

  3. DISCONNECT RADIATOR HOSE INLET

  4. REMOVE FAN SHROUD


    1. A01DWF7

      Remove the 3 bolts and oil reservoir.

    2. Disconnect the No. 1 and No. 2 water by-pass hoses from the tank upper and lower.

    3. Remove the bolt and radiator reservoir.

    4. Loosen the 4 nuts holding the fluid coupling fan.

    5. Remove the vane pump V belt, cooler compressor V belt and fan and generator V belt Click here.

    6. Remove the 2 bolts holding the fan shroud.

    7. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

      Note

      Be careful not to damage the radiator core.

    8. Remove the fan pulley from the water pump.

  5. REMOVE FAN


    1. A01DWPN

      Remove the 4 bolts and fan from the coupling.