FRONT BUMPER REMOVAL

PROCEDURE

  1. REMOVE FRONT BUMPER ASSEMBLY

    1. B512169C01
      V100155

      Protective Tape

      Apply protective tape around the front bumper assembly as shown in the illustration.

    2. B512170

      Remove the 2 clips.

      Tip:

      Use the same procedure for the RH side and LH side.

    3. B512171

      Pull back the edge of the front fender liner LH as shown in the illustration and remove the clip.

      Note:

      Do not apply excessive force when pulling back the front fender liner LH.

      Tip:

      Use the same procedure for the RH side and LH side.

    4. B512172

      Remove the 7 screws.

    5. B512173C01

      *a

      Moulding Remover

      Using a moulding remover, disengage the 4 claws as shown in the illustration.

      Tip:

      Use the same procedure for the RH side and LH side.

    6. w/o Fog Light:

      1. B514332

        Pull back the side of the front bumper assembly and disconnect the connector.

        Note:

        Do not apply excessive force when pulling back the front bumper assembly.

        Tip:

        Use the same procedure for the RH side and LH side.

    7. w/ Fog Light:

      1. B512175

        Pull back the side of the front bumper assembly and disconnect the connector.

        Note:

        Do not apply excessive force when pulling back the front bumper assembly.

        Tip:

        Use the same procedure for the RH side and LH side.

    8. B512176

      Remove the 7 clips.

    9. B512177

      Disengage the 2 claws and remove the front bumper assembly as shown in the illustration.