DIFFERENTIAL PRESSURE SENSOR ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT DIFFERENTIAL PRESSURE SENSOR


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch ON (IG).

    3. Turn the GTS on.

    4. B007Y35N01

      Enter the following menus: Powertrain / Engine / Data List / GPF Differential Pressure Sensor Bank1.


      Powertrain > Engine > Data List
      Tester Display
      GPF Differential Pressure Sensor Bank 1

    5. Enter the following menus: Powertrain / Engine / Data List / GPF Differential Pressure Sensor Bank1.

    6. Slide the clip and disconnect the vacuum transmitting hose assembly from the differential pressure sensor.

    7. Connect SST to the differential pressure sensor.

      SST
      09992-00242

    8. Using SST, apply pressure to the differential pressure sensor.

    9. Check the pressure value of the differential pressure sensor.

      Standard
      GTS Display Condition Specified Condition
      GPF Differential Pressure Sensor Bank 1 Engine switch on (IG)

      When applying 20 kPa (2.9 psi): 20 kPa (2.9 psi)

      When applying 40 kPa (5.8 psi): 40 kPa (5.8 psi)

      Note

      Perform the inspection within the range of 0 to 98 kPa (0 to 14.2 psi).

      If the result is not as specified, replace the differential pressure sensor.

    10. Disconnect SST from the differential pressure sensor.

    11. Connect the vacuum transmitting hose assembly to the differential pressure sensor and slide the clip to secure it.