EXHAUST PIPE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the exhaust pipe removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

B006DRJ

PROCEDURE


  1. REMOVE REAR FLOOR SIDE MEMBER COVER LH


    1. B006GIJ

      Remove the 2 clips, 3 bolts, screw, nut and the rear floor side member cover LH.

  2. REMOVE REAR FLOOR SIDE MEMBER COVER RH


    1. B006AZ6

      Remove the 2 clips, 3 bolts, screw, nut and the rear floor side member cover RH.

  3. REMOVE NO. 2 FLOOR BOARD SUB-ASSEMBLY


    1. B006ELM

      Remove the 10 clips, 7 grommets, 2 nuts, 2 bolts and the No. 2 floor board sub-assembly.

  4. REMOVE FLOOR BOARD SUB-ASSEMBLY


    1. B006BIY

      Remove the 10 clips, 7 grommets, 2 nuts, 2 bolts and the floor board sub-assembly.

  5. REMOVE FRONT CENTER FLOOR BRACE SUB-ASSEMBLY


    1. B0069OB

      Remove the 12 bolts and front center floor brace sub-assembly.

  6. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. B005VR3

      Remove the 4 bolts and 4 nuts to disconnect the front exhasut pipe assembly from the exhaust manifold assembly LH and exhaust manifold assembly RH.

    2. B005WSF

      Remove the 4 bolts, 4 compression springs and front exhaust pipe assembly from the exhaust tailpipe assembly.

    3. Remove the 4 gaskets.

  7. REMOVE EXHAUST TAILPIPE LH


    1. B005WYV

      Remove the 4 exhaust pipe supports and exhaust tailpipe LH.

  8. REMOVE EXHAUST TAILPIPE ASSEMBLY


    1. B005SDT

      Remove the 4 exhaust pipe supports and exhaust tailpipe assembly.