RELAY ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT DEICER RELAY

   1. 

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Condition	Specified Condition
      3 - 5	Battery voltage applied to terminals 1 and 2	Below 1 Ω
      3 - 5	Battery voltage not applied between terminals	10 kΩ or higher

      If the result is not as specified, replace the deicer relay.

2. INSPECT DEFOGGER RELAY (except Sedan)

   1. 

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Condition	Specified Condition
      3 - 4	Battery voltage applied to terminals 1 and 2	10 kΩ or higher
      3 - 4	Battery voltage not applied between terminals	Below 1 Ω
      3 - 5	Battery voltage applied to terminals 1 and 2	Below 1 Ω
      3 - 5	Battery voltage not applied between terminals	10 kΩ or higher
      4 - 5	Always	10 kΩ or higher

      If the result is not as specified, replace the defogger relay.

3. INSPECT DEFOGGER RELAY (for Sedan)

   1. 

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Condition	Specified Condition
      3 - 4	Battery voltage applied to terminals 1 and 2	10 kΩ or higher
      3 - 4	Battery voltage not applied between terminals	Below 1 Ω
      3 - 5	Battery voltage applied to terminals 1 and 2	Below 1 Ω
      3 - 5	Battery voltage not applied between terminals	10 kΩ or higher
      4 - 5	Always	10 kΩ or higher

      If the result is not as specified, replace the defogger relay.