WINDSHIELD OUTSIDE MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL NO. 3 WINDSHIELD OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a No. 3 windshield outside moulding clip is necessary.


    1. B006BE8

      Using an air riveter with a nose piece, install 5 new No. 3 windshield outside moulding clips.

      Tech Tips

      If the mandrel of the No. 3 windshield outside moulding clip does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

      Note


      • B006D78C11
        *a Riveter
        *b Mandrel
        *c Incorrect

        Do not pry the No. 3 windshield outside moulding clip with the riveter, as this will cause damage to the riveter and mandrel.

      • B006CWZC10
        *a Riveter
        *b Incorrect

        Confirm that the No. 3 windshield outside moulding clips are seated properly against the moulding.

      • Do not tilt the riveter when installing the No. 3 windshield outside moulding clip to the moulding.

      • Do not leave any space between the No. 3 windshield outside moulding clip head and moulding.

      • B006BYTC10
        *a Riveter
        *b Incorrect

        Do not leave any space between the moulding and door frame. Firmly hold the 2 items together while installing the No. 3 windshield outside moulding clip.

    2. Install the windshield glass sub-assembly.

      Click here

  2. INSTALL NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a No. 1 windshield outside moulding clip is necessary.


    1. Attach the claw as shown in the illustration to install 5 new No. 1 windshield outside moulding clips to the No. 3 windshield outside moulding clip.

      B006DCSC01
      B006DHE Install in this Direction - -

  3. INSTALL LOWER WINDSHIELD OUTSIDE MOULDING LH


    1. B006GVUC01
      B006DHE Install in this Direction

      Attach the claw.

    2. B006DGN

      Attach the claw to install the lower windshield outside moulding LH as shown in the illustration.

    3. Remove the protective tape.

  4. ADJUST FORWARD RECOGNITION CAMERA

    Click here