| DTC Code | DTC Name |
|---|---|
| B1585 | USB Device Malfunction |
DESCRIPTION
This DTC is stored when a malfunction occurs in a connected device.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1585 | USB Device Malfunction | When any of the following conditions is met:
|
|
CAUTION / NOTICE / HINT
Note
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio and display receiver assembly may not operate normally.
PROCEDURE
REPLACE USB DEVICE OR "iPod"
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Turn the ignition switch off.
Tech Tips
When this DTC has been stored, it is necessary to turn the ignition switch off to make it possible for the vehicle to recognize a new device when it is connected.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
Tech Tips
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
Refer to System Description for compatible formats and versions.
| Result | ||
|---|---|---|
|
| NEXT |
|
CHECK DTC
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
| OK |
|---|
| No DTCs are output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
END (USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE) |
| NG |
|
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Click here |