ENGINE SWITCH INSPECTION

PROCEDURE

1. INSPECT ENGINE SWITCH

   1. 

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Switch Condition	Specified Condition
      7 (SS1) - 5 (GND)	Pushed	Below 1 Ω
      2 (SS2) - 5 (GND)	Pushed	Below 1 Ω
      7 (SS1) - 5 (GND)	Not pushed	10 kΩ or higher
      2 (SS2) - 5 (GND)	Not pushed	10 kΩ or higher

      Table 1. Text in Illustration

      *1	Component without harness connected (Engine Switch)

      If the result is not as specified, replace the engine switch.

   2. Apply battery voltage to the terminals of the switch and check the illumination condition of the switch.

      

      OK

      Measurement Condition	Specified Condition
      Battery positive (+) → Terminal 11 (SWIL) Battery negative (-) → Terminal 5 (GND)	Illuminates (illumination of lettering)
      Battery positive (+) → Terminal 12 (INDS) Battery negative (-) → Terminal 5 (GND)	Illuminates (green)
      Battery positive (+) → Terminal 13 (INDW) Battery negative (-) → Terminal 5 (GND)	Illuminates (amber)

      Note:

      • If the positive (+) lead and negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.

      • If the voltage is too low, the indicator will not illuminate.

      If the result is not as specified, replace the engine switch.