WINDSHIELD OUTSIDE MOULDING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the windshield outside moulding removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Windshield glass (Removal and installation) Adjust forward recognition camera

  • Dynamic radar cruise control system

  • Forward recognition camera system

  • LKA/LDA system

  • Road sign assist system

  • Pre-collision system

  • Automatic high beam system

  • Adaptive high beam system

Click here

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE LOWER WINDSHIELD OUTSIDE MOULDING LH


    1. B006A27C01
      B006GBM Protective Tape

      Put protective tape around the lower windshield outside moulding LH.

    2. B006AC2C01
      B006DHE Remove in this Direction

      Detach the claw as shown in the illustration.

    3. B006AG2C03
      B006DHE Remove in this Direction

      Using a screwdriver, detach the claw and remove the lower windshield outside moulding LH.

      Tech Tips

      Tape the screwdriver tip before use.

  2. REMOVE NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a No. 1 windshield outside moulding clip is necessary.


    1. B006E84C01
      B006DHE Remove in this Direction

      Detach the claw as shown in the illustration to remove the 5 No. 1 windshield outside moulding clips.

  3. REMOVE NO. 3 WINDSHIELD OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a No. 3 windshield outside moulding clip is necessary.


    1. Remove the windshield glass sub-assembly.

      Click here

    2. Insert a 4.0 mm (0.157 in.) drill bit into a drill.

    3. B006E17C07
      *a Tape

      Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.

      Standard Measurement
      Area Measurement
      A 5.0 mm (0.197 in.)

      Note

      Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

    4. B006D27C02
      *a Flange

      Lightly press the drill against the No. 3 windshield outside moulding clips to drill off the No. 3 windshield outside moulding clip flanges, and remove the 5 No. 3 windshield outside moulding clips.

      CAUTION:

      Be careful of the drilled No. 3 windshield outside moulding clips, as they may be hot.

      Note


      • Pressing the drill too firmly will cause the No. 3 windshield outside moulding clip to turn and result in the No. 3 windshield outside moulding clip not being drilled through.

      • Prying the No. 3 windshield outside moulding clips with the drill may damage the No. 3 windshield outside moulding clip installation holes or drill bit.

    5. Using a vacuum cleaner, remove the No. 3 windshield outside moulding clip fragments and shavings from the drilled areas.