REFRIGERANT LINE REMOVAL

PROCEDURE


  1. REMOVE RADIATOR COVER PLATE

    Click here

  2. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  3. REMOVE LOWER RADIATOR AIR DEFLECTOR

    Click here

  4. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM


    1. for HFC-134a(R134a):

      Click here

    2. for HFO-1234yf(R1234yf):

      Click here

  5. REMOVE PIPING CLAMP (for Rear Side)


    1. B006D6RC01
      *1 Air Conditioning Tube and Accessory Assembly
      *2 Cooler Refrigerant Liquid Pipe A

      Install SST to the piping clamp as shown in the illustration.

      SST
      09870-00025
    2. B006GSPC01
      *a Push in

      Hold the air conditioning tube and accessory assembly and cooler refrigerant liquid pipe A with each hand and push in SST with both thumbs.

      Note

      Do not apply excessive force to the air conditioning tube and accessory assembly or cooler refrigerant liquid pipe A as they may bend.

    3. B006DQAC01
      *1 Air Conditioning Tube and Accessory Assembly
      *a Stopper
      *b Pull off

      Raise the stopper of SST and remove SST and the piping clamp together from the air conditioning tube and accessory assembly.

    4. Remove the piping clamp from SST.

    5. Disconnect the cooler refrigerant liquid pipe A from the air conditioning tube and accessory assembly.

    6. Remove the 2 O-rings from the cooler refrigerant liquid pipe A.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  6. REMOVE HEADLIGHT ASSEMBLY LH

    Click here

  7. REMOVE PIPING CLAMP (for Front Side)


    1. B006D6RC01
      *1 Liquid Tube Sub-assembly A
      *2 Cooler Refrigerant Liquid Pipe A

      Install SST to the piping clamp as shown in the illustration.

      SST
      09870-00025
    2. B006GSPC01
      *a Push in

      Hold the cooler refrigerant liquid pipe A and liquid tube sub-assembly A with each hand and push in SST with both thumbs.

      Note

      Do not apply excessive force to the cooler refrigerant liquid pipe A or liquid tube sub-assembly A as they may bend.

    3. B006DQAC01
      *1 Cooler Refrigerant Liquid Pipe A
      *a Stopper
      *b Pull off

      Raise the stopper of SST and remove SST and the piping clamp together from the cooler refrigerant liquid pipe A.

    4. Remove the piping clamp from SST.

    5. Remove the cooler refrigerant liquid pipe A from the liquid tube sub-assembly A.

    6. Remove the 2 O-rings from the liquid tube sub-assembly A.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.