WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

  • If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.

  • Ensure that the headlight assembly is not damaged.

  1. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER

    1. E392065

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E392066

      Install the upper headlight protector retainer with the 2 screws.

  2. INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER

    1. E392067

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E392068

      Install the upper No. 2 headlight protector retainer with the 2 screws.

  3. INSTALL LOWER HEADLIGHT PROTECTOR RETAINER

    1. E392069

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E392070

      Install the lower headlight protector retainer with the 2 screws.