REAR AIRBAG SENSOR (for Double Cab) INSTALLATION


  1. INSTALL REAR AIRBAG SENSOR LH


    1. A01DXJX

      Check that the ignition switch is off.

    2. Check that the cable is disconnected from the battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install the rear airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that there is no looseness in the installation parts of the rear airbag sensor.

    5. Connect the connector.

  2. INSTALL LOWER QUARTER TRIM PANEL LH


    1. Attach the 3 clips and claw to install the lower quarter trim panel.

  3. INSTALL REAR DOOR OPENING TRIM LH

  4. INSTALL REAR DOOR SCUFF PLATE LH


    1. Attach the 2 clips and 7 claws to install the rear door scuff plate.

  5. INSTALL REAR SEAT ASSEMBLY


    1. Install the rear seat assembly Click here.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  7. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.