TRANSFER OIL REPLACEMENT

PROCEDURE


  1. DRAIN TRANSFER OIL


    1. Stop the vehicle on a level surface.

    2. A01XOEEC01
      *1 No. 2 Transfer Case Plug (for filler)
      *2 Transfer Drain Plug

      Using a 10 mm straight hexagon wrench and 10 x 12 mm long offset wrench, remove the No. 2 transfer case plug (for filler) and gasket.

    3. Using a 10 mm hexagon socket wrench, remove the transfer drain plug and gasket and drain the transfer oil.

    4. Using a 10 mm hexagon socket wrench, install a new gasket and the drain plug.

      Torque:
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

  2. ADD TRANSFER OIL


    1. Add transfer oil.

      Oil grade
      Toyota Genuine Differential gear oil LT API GL-5 or equivalent
      Viscosity
      SAE 75W-85
    2. A01XOF9C01
      *a 0 to 5.0 mm (0 to 0.196 in.)

      Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the No. 2 transfer case plug (for filler) hole.

      Note


      • When adding oil, pour it slowly.

      • Add oil a little at a time, waiting several minutes between each addition of oil.

      • Too much or too little oil will lead to transfer problems.

      Standard Capacity
      0.40 to 0.50 liters (0.43 to 0.52 US qts, 0.36 to 0.44 Imp.qts)

    3. Wait approximately 5 minutes and check that the oil level has not changed.

    4. A01XPEPC01
      *1 10 mm Straight Hexagon Wrench
      *2 12 mm Hexagon Socket Wrench
      *3 10 x 12 mm Long Offset Wrench
      *a Torque Wrench Fulcrum Length

      Using a 10 mm straight hexagon wrench, 12 mm hexagon socket wrench and 10 x 12 mm long offset wrench, install a new gasket into the No. 2 transfer case plug (for filler) and then install the No. 2 transfer case plug (for filler).

      Torque:
      Specified tightening torque
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

      Note

      After adding oil, drive the vehicle and recheck the oil level.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a long offset wrench (fulcrum length of 189.75 mm (7.4705 in.)) + torque wrench (fulcrum length of 255 mm (10.0394 in.)): 22.4 N*m (228 kgf*cm, 17 ft.*lbf)