REAR CRANKSHAFT OIL SEAL REMOVAL


  1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  2. REMOVE FLYWHEEL SUB-ASSEMBLY


    1. B007Q6I

      Remove the 4 bolts and crankshaft pulley cover from the crankshaft pulley.

    2. B007PV4E01

      Using SST, hold the crankshaft pulley.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
    3. B007QEL

      Remove the 8 bolts, rear drive plate spacer, pump impeller drive plate and flywheel sub-assembly from the crankshaft.

  3. REMOVE REAR END PLATE


    1. B007VM0

      Remove the bolt and rear end plate from the cylinder block sub-assembly.

  4. REMOVE REAR ENGINE OIL SEAL


    1. B007PX8E01
      Text in Illustration
      *a Protective Tape
      *b Cloth
      *c Cut

      Using a knife, cut off the lip of the rear engine oil seal.

    2. Using a cloth and screwdriver, pry out the rear engine oil seal from the rear engine oil seal retainer.

      Note

      Be careful not to damage the crankshaft and rear engine oil seal retainer.

      Tech Tips


      • After removal, check the crankshaft for damage. If damaged, smooth the surface with #400 sandpaper.

      • Tape the screwdriver tip before use.