REAR CENTER SEAT OUTER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side) INSTALLATION
CAUTION / NOTICE / HINT
Wear protective gloves. Sharp areas on the parts may injure your hands.
A bolt without a torque specification is shown in the standard bolt chart (Click here).
PROCEDURE
INSTALL NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH
*1
Bolt
*2
Nut
Note:When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.
Align the seat belt positioning holes with the claws and install the retractor of the seat belt with the nut and bolt as shown in the illustration.
Tip:First install the bolt, and then install the nut.
for bolt
7.5 N*m
76 kgf*cm
66 in.*lbf
for nut
42 N*m
428 kgf*cm
31 ft.*lbf
INSTALL REAR SEATBACK EDGE PROTECTOR
INSTALL REAR SEAT SHOULDER BELT GUIDE
INSTALL SEATBACK COVER WITH PAD
INSTALL REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY
INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY LH
INSTALL REAR SEATBACK COVER
INSTALL REAR SEAT SHOULDER BELT COVER
INSTALL SEAT BELT ANCHOR COVER CAP
INSTALL REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH
INSTALL RECLINING ADJUSTER KNOB CAP LH
INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
*a
Protruding Part
Install the inner belt and connect the 3 point type belt anchor with the bolt.
42 N*m
428 kgf*cm
31 ft.*lbf
Note:Do not allow the anchor part of the anchor plate sub-assembly to overlap the protruding parts of the seatback frame.
INSTALL CENTER SEATBACK ASSEMBLY
INSTALL SEAT CUSHION COVER WITH PAD
INSTALL REAR SEATBACK LOCK STRIKER COVER LH
INSTALL REAR SEAT CUSHION MOULDING LH
INSTALL CENTER SEAT HINGE COVER RH
INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
INSTALL REAR SEAT UPPER RECLINING COVER LH
INSTALL REAR NO. 1 SEAT ASSEMBLY LH
Install the rear No. 1 seat assembly LH (Click here).