CENTER AIRBAG SENSOR ASSEMBLY REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 1 DECK BOARD

    Click here

  4. REMOVE NO. 2 DECK BOARD

    Click here

  5. REMOVE REAR DECK FLOOR BOX

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  9. REMOVE AIRBAG ECU ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Turn back the carpet.

    4. B005YT1

      Disconnect the connectors from the airbag ECU assembly as shown in the illustration.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    5. B005XM0

      Remove the 3 bolts and airbag ECU assembly.