BACK DOOR CLOSER SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Back Door, Main Body or Entry & Start / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Back Door > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Door Lock Status Back door condition signal Lock or Unlock

      Lock: Back door locked

      Unlock: Back door unlocked

      		 -
      Half Latch SW Half-latch switch signal OFF or ON

      OFF: Back door lock motor in full latch or half latch position

      ON: Back door lock motor in open latch position

      		 *
      Closer Position SW Position switch signal OFF or ON

      OFF: Back door lock assembly (position switch) off

      ON: Back door lock assembly (position switch) on

      		 *
      Pawl Position Switch Pawl switch signal OFF or ON

      OFF: Back door lock assembly (pawl switch) off

      ON: Back door lock assembly (pawl switch) on

      		 *
      Courtesy SW Latch courtesy switch signal OFF or ON

      OFF: Back door closed

      ON: Back door open

      		 *
      IG SW Engine switch signal OFF or ON

      OFF: Engine switch off

      ON: Engine switch on (IG)

      		 "OFF" is also displayed for this item when the engine switch is on (ACC).
      #Codes The number of DTCs 0 to 255 The number of DTCs -

      *: Refer to Construction and Operation

      Click here


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Back Door Courtesy SW Back door courtesy light switch signal OFF or ON

      OFF: Back door closed

      ON: Back door open

      		 For vehicles with power back door system, this item is not related to back door condition.
      Back Door Open Back door condition signal Prohibit or Permit

      Prohibit: Back door locked

      Permit: Back door unlocked

      		 -

      Body Electrical > Entry&Start > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Tr/B-Door Unlock SW Back door opener switch assembly (open switch) signal OFF or ON

      OFF: Back door opener switch assembly (open switch) off

      ON: Back door opener switch assembly (open switch) on

      		 -