FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE

  1. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  2. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  3. REMOVE REAR ENGINE UNDER COVER RH

    Click hereClick here

  4. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click hereClick here

  5. REMOVE V-RIBBED BELT

    Click here

  6. REMOVE CRANKSHAFT PULLEY

    1. A293587C01

      *a

      Hold
      V100135

      Turn

      Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen pulley the bolt until 2 or 3 threads are screwed into the crankshaft.

      09213-54015

      09330-00021

      Tip:

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-00850 (quantity: 2).

    2. A234912C05

      *a

      Hold
      V100135

      Turn

      Using SST and the pulley bolt, remove the crankshaft pulley and pulley bolt.

      09950-50013

      09951-05010

      09952-05010

      09953-05020

      09954-05021

      Tip:

      Apply lubricant to the threads and end of SST.

  7. REMOVE TIMING CHAIN COVER OIL SEAL

    1. A200713C01

      *1

      Protective Tape

      Using a screwdriver, pry out the oil seal.

      Note:

      • Do not damage the surface of the oil seal press fit hole or the crankshaft.

      • After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.

      Tip:

      Tape the screwdriver tip before use.