RELAY ON-VEHICLE INSPECTION

PROCEDURE

  1. INSPECT HORN RELAY

    1. E295884C01

      *a

      Component without harness connected

      (HORN Relay)

      Remove the HORN relay.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      3 - 5

      Battery voltage not applied between terminals 1 and 2

      10 kΩ or higher

      3 - 5

      Battery voltage applied between terminals 1 and 2

      Below 1 Ω

      If the result is not as specified, replace the HORN relay.