ECD SYSTEM (w/o EGR Cooler) BASIC INSPECTION

Tech Tips

When a malfunction cannot be confirmed by the DTC check, troubleshooting should be performed on all circuits that are possible causes of the problem. However, in most cases, performing the basic engine check shown below can help you find the problem quickly and efficiently. Always perform this check first when troubleshooting the engine.


  1. CHECK BATTERY VOLTAGE

    Note

    Perform the battery voltage check with the engine stopped and ignition switch OFF.

    OK
    Battery voltage is 11 V or more.

    NG

    CHARGE OR REPLACE BATTERY
    OK

  2. CHECK IF ENGINE WILL CRANK


    NG

    PROCEED TO PROBLEM SYMPTOMS TABLE
    OK

  3. CHECK AIR FILTER


    1. Visually check that the air filter is not excessively contaminated with dirt or oil.


      NG

      CLEAN OR REPLACE AIR FILTER
      OK

  4. CHECK FUEL QUALITY


    1. Check that only diesel fuel is used.

    2. Check that the fuel does not contain any impurities.


      NG

      REPLACE FUEL
      OK

  5. CHECK FUEL FOR AIR


    NG

    BLEED FUEL OF AIR
    OK

  6. CHECK FUEL PIPES AND HOSES


    1. Check that the fuel pipes and fuel hoses are not blocked, damaged, disconnected or bent.


      NG

      REPAIR OR REPLACE
      OK

  7. CHECK FUEL FILTER FOR BLOCKAGE


    NG

    REPAIR OR REPLACE
    OK

  8. CHECK ENGINE OIL


    NG

    ADD OR REPLACE
    OK

  9. CHECK ENGINE COOLANT


    NG

    ADD OR REPLACE ENGINE COOLANT
    OK

  10. CHECK IDLING SPEED AND MAXIMUM SPEED


    NG

    REPLACE SUPPLY PUMP ASSEMBLY
    OK

  11. CHECK DIAGNOSTIC CIRCUIT


    NG

    REPAIR OR REPLACE
    OK

  12. CHECK VACUUM PUMP


    NG

    REPAIR OR REPLACE VACUUM PUMP
    OK
    PROCEED TO PROBLEM SYMPTOMS TABLE