BRAKE BOOSTER(for RHD) REMOVAL

CAUTION / NOTICE / HINT

Note:

Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  4. REMOVE COWL VENTILATOR HOUSING SUB-ASSEMBLY

    1. C278611

      Disengage the 3 clips and remove the cowl ventilator housing sub-assembly.

  5. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY

    1. C278594

      Disconnect the connector.

    2. Remove the 13 bolts and cowl top panel outer sub-assembly.

  6. REMOVE COWL BODY MOUNTING REINFORCEMENT RH

    1. C170048

      Remove the 2 nuts and cowl body mounting reinforcement RH.

  7. DRAIN BRAKE FLUID

    Note:

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  8. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

    Click here

  9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Driver Side Knee Airbag)

    Click here

  10. REMOVE BRAKE PEDAL RETURN SPRING

    Click here

  11. REMOVE PUSH ROD PIN

    Click here

  12. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

    1. Loosen the push rod clevis lock nut.

    2. Remove the push rod clevis.

  13. REMOVE VACUUM HOSE

    1. Slide the clip and disconnect the vacuum hose.

  14. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

    Click here

  15. REMOVE BRAKE BOOSTER ASSEMBLY

    1. C126454

      Remove the 4 nuts.

    2. Pull out the booster with the gasket.

      Note:

      Do not damage the brake lines.

  16. REMOVE BRAKE BOOSTER GASKET

  17. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY

    1. Remove the brake vacuum check valve from the brake booster.

  18. REMOVE CHECK VALVE GROMMET

    1. Remove the check valve grommet from the brake booster.

  19. REMOVE VACUUM SENSOR ASSEMBLY (for 1AD-FTV)

    1. Remove the vacuum sensor from the brake booster.

  20. REMOVE VACUUM SENSOR GROMMET (for 1AD-FTV)

    1. Remove the vacuum sensor grommet from the brake booster.