GENERATOR REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. REMOVE NO. 1 ENGINE COVER

    1. U122244E02

      Lift the No. 1 engine cover to detach the 4 clips in the order shown in the illustration and remove the No. 1 engine cover.

      Note:

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover to break.

  4. REMOVE RADIATOR SUPPORT OPENING COVER

    1. A316693

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  5. REMOVE INTAKE MANIFOLD

    (Click here)

  6. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  7. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  8. REMOVE FAN AND GENERATOR V BELT

    Click here

  9. REMOVE GENERATOR ASSEMBLY

    1. A316694

      Disconnect the generator connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the generator wire.

    4. A316695E02

      Using an E12 "TORX" socket wrench, remove the 2 bolts as shown in the illustration.

      Tip:

      Bolt A cannot be removed with the generator assembly installed to the vehicle.

    5. A316696

      Remove the generator assembly as shown in the illustration.