AUDIO AND VISUAL SYSTEM Reverse Signal Circuit

DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the power management control ECU via the No. 1 integration relay.

WIRING DIAGRAM

A005AORE24

PROCEDURE


  1. INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY


    1. Disconnect the L35 radio and display receiver assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L35-2 (REV) - Body ground

      Power switch on (READY)

      Reverse (R) selected

      		 11 to 15.5 V
      L35-2 (REV) - Body ground

      Power switch on (READY)

      Reverse (R) not selected

      		 Below 1 V

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 INTEGRATION RELAY)


    1. Disconnect the L35 radio and display receiver assembly connector.

    2. Disconnect the 1G No. 1 integration relay connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L35-2 (REV) - 1G-4 (NAV) Always Below 1 Ω
      L35-2 (REV) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - POWER MANAGEMENT CONTROL ECU)


    1. Disconnect the 1G No. 1 integration relay connector.

    2. Disconnect the A21 power management control ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1G-13 (BKUP) - A21-15 (BL) Always Below 1 Ω
      1G-13 (BKUP) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. REPLACE NO. 1 INTEGRATION RELAY


    1. Replace the No. 1 integration relay with a new or known good one Click here.

    2. Check that the malfunction disappears.

      OK
      Malfunction disappears.

    OK

    END (NO. 1 INTEGRATION RELAY WAS DEFECTIVE)

    NG

    REPLACE POWER MANAGEMENT CONTROL ECU Click here