PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:B2007

DTC Code DTC Name
B2007 Open in Seat Belt Motor LH Circuit

DESCRIPTION

The seat belt control ECU receives information from the driving support ECU assembly using CAN communication and tightens the seat belt by operating the motor in the front seat outer belt assembly LH.

DTC No. DTC Detection Condition Trouble Area
B2007 Open in the seat belt motor LH circuit continues for 1 second or more.

  • Front seat outer belt assembly LH

  • Wire harness or connector (seat belt control ECU - front seat outer belt assembly LH)

  • Seat belt control ECU

WIRING DIAGRAM

A005BE6E03
*a Front Seat Outer Belt Assembly LH
*b Seat Belt Control ECU

CAUTION / NOTICE / HINT

CAUTION:

The pretensioner is built into the front seat outer belt assembly LH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

PROCEDURE


  1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY LH


    1. A005AWNE01
      Text in Illustration
      *a

      Component without harness connected

      (Front Seat Outer Belt Assembly LH)

      Disconnect the R8 front seat outer belt assembly LH connector.

      Tech Tips

      Do not remove the front seat outer belt assembly LH.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      R8-1 (MOL+) - R8-2 (MOL-) Always Below 20 Ω

      CAUTION:

      Do not check a wrong connector.


    NG

    REPLACE FRONT SEAT OUTER BELT ASSEMBLY LH Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY LH - SEAT BELT CONTROL ECU)


    1. Disconnect the L2 seat belt control ECU connector.

    2. Using a service wire, connect 1 and 2 of the connector on the front seat outer belt assembly LH.

      Note

      Do not forcibly insert the service wire into the terminals of the connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L2-3 (MOL+) - L2-4 (MOL-) Always Below 1 Ω

    4. Disconnect the service wire from the connector.


    OK

    REPLACE SEAT BELT CONTROL ECU Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY LH - SEAT BELT CONTROL ECU)