REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

    Click here

  2. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

    Click here

  3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


    1. A004KUQE01

      Using SST, hold the crankshaft.

      SST
      09960-10010   ( 09962-01000, 09963-01000 )
    2. A004K0J

      Remove the 8 bolts, drive plate and ring gear sub-assembly and rear drive plate spacer.

  4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

    Click here

  5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Click here

  6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


    1. A004KUQE01

      Using SST, hold the crankshaft.

      SST
      09960-10010   ( 09962-01000, 09963-01000 )
    2. A004HTS

      Remove the 8 bolts and flywheel sub-assembly.

  7. REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE


    1. Remove the No. 1 crankshaft position sensor plate.

  8. REMOVE REAR ENGINE OIL SEAL


    1. A004JPME01
      Text in Illustration
      *1 Protective Tape
      *a Cut position

      Using a knife, cut through the oil seal lip.

    2. Using a screwdriver with its tip taped, pry out the rear engine oil seal.

      Note

      After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

      Tech Tips

      Tape the screwdriver tip before use.