FUEL PUMP INSPECTION


  1. INSPECT FUEL PUMP


    1. A01DV1KE01

      Check the fuel pump resistance.


      1. Using an ohmmeter, measure the resistance between terminals 4 and 5.

        Standard resistance
        0.2 to 3.0 at 20°C (68°F)

        If the result is not as specified, replace the fuel pump.

    2. Check fuel pump operation.


      1. Apply battery voltage to terminals 4 and 5. Check that the pump operates.

        Note


        • This test must be completed within 10 seconds to prevent the coil from burning out.

        • Keep fuel pump as far away from the battery as possible.

        • Always turn on and off the voltage on the battery side, not the fuel pump side.

        If the pump does not operate, replace the fuel pump.

  2. INSPECT FUEL PUMP RELAY ASSEMBLY

    A01DYG8E01

    1. Check the resistance.


      1. Using an ohmmeter, check the resistance between each terminal.

        Standard resistance
        Tester Connection Specified Condition

        1 - 2

        3 - 4

        		 Below 1 Ω
        3 - 5 10 kΩ or higher

      2. Using an ohmmeter, check the resistance between terminals 3 and 5 when the battery voltage is applied across terminals 1 and 2.

        Specified condition
        Below 1 Ω