DIFFERENTIAL PRESSURE SENSOR(w/o Glow Plug Controller) INSTALLATION

PROCEDURE

1. INSTALL DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

   1. 

      *1	Vacuum Transmitting Hose Assembly
      *2	No. 2 Vacuum Transmitting Hose Assembly
      *a	View A
      *b	Paint Mark (Yellow)
      *c	Paint Mark (Pink)

      Connect the vacuum transmitting hose assembly and No. 2 vacuum transmitting hose assembly to the differential pressure sensor assembly and slide the 2 clips to secure them.

      Note:

      Connect the vacuum transmitting hose assembly and No. 2 vacuum transmitting hose assembly so that the paint marks of the vacuum transmitting hose assembly and No. 2 vacuum transmitting hose assembly are as shown in the illustration.

   2. 

      Install the differential pressure sensor assembly and bracket with the bolt .

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

   3. 

      Connect the connector to the differential pressure sensor assembly.

2. INSTALL OUTER COWL TOP PANEL (for LHD)

   • for Sedan:

     Click hereClick hereClick here

   • for Hatchback, Wagon:

     Click hereClick hereClick here

3. INSTALL OUTER COWL TOP PANEL (for RHD)

   • for Sedan:

     Click hereClick here

   • for Hatchback, Wagon:

     Click hereClick here

4. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)

   • for Sedan:

     Click hereClick hereClick here

   • for Hatchback, Wagon:

     Click hereClick hereClick here

5. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)

   • for Sedan:

     Click hereClick here

   • for Hatchback, Wagon:

     Click hereClick here

6. INSTALL WATER GUARD PLATE LH (for LHD)

   • for Sedan:

     Click hereClick hereClick here

   • for Hatchback, Wagon:

     Click hereClick hereClick here

7. INSTALL WATER GUARD PLATE LH (for RHD)

   • for Sedan:

     Click hereClick here

   • for Hatchback, Wagon:

     Click hereClick here

8. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

   Click here

9. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

   Click hereClick here

10. LEARNING DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

    1. Start the engine and wait until the engine coolant temperature reaches 75°C (167°F) or more (A).

    2. Turn the ignition switch off and wait for 30 seconds or more (B).

    3. Repeat the above procedures (A) and (B) 3 times.

       Tip:

       • Procedures (A) and (B) must be repeated 3 times to complete the differential pressure sensor learning process.

       • If the differential pressure sensor learning is incomplete, DTC P244A may be stored.