REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE

INSTALL REAR ENGINE OIL SEAL
1. Apply engine oil to the lip of a new rear engine oil seal.
  
  Note
  
  Keep the lip free of foreign matter.
2. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
  
  SST
  
  09223-15030
  
  09950-70010 ( 09951-07150 )
  
  Oil seal tap in depth
  
  0 to 1.0 mm (0 to 0.0394 in.)
  Note
  
  Wipe any extra grease off of the crankshaft.
  
  Keep the lip free of foreign matter.
  
  Do not tap on the oil seal at an angle.
INSTALL NO. 1 CRANKSHAFT POSITION SENSOR PLATE
1. Clean the 8 bolts and 8 bolt holes.
2. Text in Illustration
  
  *1 Pin Hole
  
  *2 Pin
  
  Install the No. 1 crankshaft position sensor plate.
  
  Tech Tips
  
  Align the pin of the front drive spacer with the pin hole of the crankshaft.
INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)
1. Using SST, hold the crankshaft pulley.
  
  SST
  
  09960-10010 ( 09962-01000, 09963-01000 )
2. Install the flywheel sub-assembly onto the crankshaft.
3. In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.
  
  Torque:
  
  85 N*m { 867 kgf*cm, 63 ft.*lbf }
INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)

Click here
INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)

Click here
INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)
1. Using SST, hold the crankshaft pulley.
  
  SST
  
  09960-10010 ( 09962-01000, 09963-01000 )
2. Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.
3. In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.
  
  Torque:
  
  95 N*m { 969 kgf*cm, 70 ft.*lbf }
REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

Click here
INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Click here
INSPECT FOR OIL LEAK

Text in Illustration
*1	Pin Hole
*2	Pin