OIL LEVEL SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the engine oil level sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking Assist Monitor System

Click here

Panoramic View Monitor System

Click here

Replacement of ECM Vehicle Identification Number (VIN) registration MIL comes on

Click here

Perform code registration (Immobiliser system) Engine start function See Service Bulletin for the registration method.

  • Replacement of engine assembly

  • Gas leak from exhaust system is repaired

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

Replacement of automatic transaxle assembly

  1. Reset Memory

  2. Input transaxle compensation code into ECM

  3. Perform road test to allow ECM to learn

  • Large shift shock

  • Deterioration of fuel efficiency

Click here

for Initialization

Click here

for Registration

Replacement of ECM

(If possible, read the transaxle compensation code from the previous ECM)

  1. Reset memory*1

  2. Transfer transaxle compensation code

  3. Perform road test to allow ECM to learn

Replacement of ECM

(If impossible, read the transaxle compensation code from the previous ECM)

  1. Reset memory*1

  2. Reset transaxle compensation code

  3. Perform road test to allow ECM to learn
Replacement of ECM Perform code registration (Immobiliser function)

  • Wireless door lock control system

  • Smart Entry and Start System (for Entry Function)

  • Smart Entry and Start System (for Start Function)

  • Steering lock function

 See Service Bulletin for the registration method.

Suspension, tires, etc.

(The vehicle height changes because of suspension or tire replacement)

 Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system

Click here

for Initialization

Click here

for Calibration

  • Television camera controller initialization

  • Adjust steering angle

  • Rear television camera assembly optical axis (Back camera position setting)

 Panoramic view monitor system

Click here

for Initialization

Click here

for Calibration
Perform headlight ECU sub-assembly LH initialization Lighting system (EXT)

Click here

Front wheel alignment adjustment Perform system variant learning and acceleration sensor zero point calibration.

  • VSC disabled or malfunctioning

  • DTCs are output

  • Slip indicator light illuminated

  • ABS warning light illuminated

Click here

*1: When the ECM is replaced with a new one, reset memory is unnecessary.

CAUTION:


  • B0087KXC01
    *a An Object Exceeding Weight Limit of Engine Lifter

    The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.

  • B0086SF

    To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

PROCEDURE


  1. INSTALL ENGINE ASSEMBLY TO ENGINE STAND

    Click here

  2. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY

    Click here

  3. REMOVE OIL STRAINER SUB-ASSEMBLY

    Click here

  4. REMOVE ENGINE OIL LEVEL SENSOR


    1. B0086MQ

      Remove the clip from the engine oil level sensor.

    2. B0083C5

      Remove the 2 nuts and engine oil level sensor from the oil pan sub-assembly.