STARTER INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

      Torque:

      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   2. Connect the wire harness to the terminal 30 with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   3. Close the terminal cap.

   4. Connect the starter assembly connector.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Click here

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. INSTALL NO. 1 ENGINE UNDER COVER

   Click here