INSTRUMENT PANEL SPEAKER REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. REMOVE FRONT PILLAR GARNISH LH

    Click hereClick here

  4. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

    1. B222517

      Detach the claws and clips shown in the illustration on the bottom of the panel. Then, using the 2 claws on the side of the panel towards the front of the vehicle as pivot points, lift up the panel in the direction indicated by the arrow in the illustration until the speaker connector can be disconnected.

    2. B222518

      Disconnect the connector and remove the panel together with the speaker.

  5. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

    1. B222515

      Detach the 3 claws and remove the front No. 2 speaker from the speaker panel.

      Note:

      Do not touch the cone part of the speaker.