VACUUM PUMP(for 3ZR-FAE) INSPECTION

PROCEDURE

  1. INSPECT VACUUM PUMP VANE

    1. C169339C03

      *1

      Vacuum Pump Vane Cap

      *2

      Vacuum Pump Vane

      Check that the vacuum pump vane or vacuum pump vane caps are not damaged or excessively worn out.

      Tip:

      If the vacuum pump vane or vacuum pump vane caps are damaged or excessively worn out, replace the damaged parts with new ones.

    2. C169340E01

      Using a micrometer, measure length A of the vacuum pump vane with the vacuum pump vane caps removed.

      Minimum length A

      23.8 mm (0.937 in.)

      Tip:

      If the length is not as specified, replace the vacuum pump vane and vacuum pump vane caps with new ones.

      Note:

      Measure the length 10 mm (0.394 in.) in from each end of the vacuum pump vane.

    3. C169342C02

      *1

      Vacuum Pump Vane

      *2

      Vacuum Vane Cap

      Using a vernier caliper, measure length B of the vacuum pump vane with the vacuum pump vane caps installed.

      Minimum length B

      76.0 mm (3.00 in.)

      Tip:

      If the length is not as specified, replace the vacuum pump vane and vacuum pump vane caps with new ones.

      Note:

      Measure the length 5 mm (0.197 in.) in from each end of the vacuum pump vane caps.

  2. INSPECT VACUUM PUMP HOUSING

    1. C169338

      Check that the rotor part, coupling, vacuum pump housing or vacuum end cover is not damaged or excessively worn out.

      Tip:

      If the rotor part, coupling, vacuum pump housing or vacuum end cover is damaged or excessively worn out, replace the vacuum pump assembly.