SPIRAL CABLE INSTALLATION

PROCEDURE

1. INSTALL SPIRAL CABLE SUB-ASSEMBLY

   Note:

   • Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch ON.

   • Do not rotate the spiral cable sub-assembly without the steering wheel assembly with the battery connected and the ignition switch ON.

   • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

   1. Check that the ignition switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. Check that the front wheels are facing straight ahead.

   4. Set the turn signal switch to the neutral position.

      Note:

      If it is not in the neutral position, the turn signal switch pin may break.

   5. Engage the 3 claws to install the spiral cable sub-assembly.

   6. Connect each connector.

2. INSTALL UPPER NO. 2 STEERING COLUMN COVER

   Click here

3. INSTALL LOWER STEERING COLUMN COVER

   Click here

4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

5. INSPECT AND ADJUST SPIRAL CABLE SUB-ASSEMBLY

   Note:

   Do not adjust the spiral cable sub-assembly with the battery connected and the ignition switch ON.

   1. Check that the ignition switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. 

      *a	Colored Part (Orange)
      *b	Alignment Mark

      Check if the spiral cable sub-assembly is centered.

      Tip:

      When the spiral cable sub-assembly is centered, the alignment marks are aligned and the colored part (orange) shown in the illustration is visible.

   4. If the spiral cable sub-assembly is not centered, center it.

      Note:

      Do not turn the spiral cable sub-assembly using the airbag wire harness.

      1. 

         Rotate the spiral cable sub-assembly counterclockwise slowly by hand until it stops.

      2. 

         *a	Colored Part (Orange)
         *b	Alignment Mark

         Rotate the spiral cable sub-assembly clockwise approximately 2.5 times to align the alignment marks and the position where the colored part (orange) shown in the illustration is visible.

         Tip:

         The spiral cable sub-assembly will rotate approximately 2.5 times to both the left and right from the center.

6. INSTALL STEERING WHEEL ASSEMBLY

   Click here