HAZARD WARNING SWITCH REMOVAL

Tech Tips


  • Use the same procedures for the RH and LH sides.

  • The procedures listed below are for the LH side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER


    1. for Manual Air Conditioning System:


      1. A01DVOWE01
        Text in Illustration
        *1 Protective Tape

        Put protective tape around the center instrument cluster finish panel.

      2. Using a moulding remover, detach the 10 claws and 4 clips.

      3. A01E1XL

        Detach the 4 claws and disconnect the air conditioner control.

      4. Disconnect the connectors and remove the center instrument cluster finish panel.

    2. for Automatic Air Conditioning System:


      1. A01DYRHE01
        Text in Illustration
        *1 Protective Tape

        Put protective tape around the center instrument cluster finish panel.

      2. Using a moulding remover, detach the 8 claws and 4 clips.

      3. Disconnect the connectors and remove the center instrument cluster finish panel.

  3. REMOVE HEATER CONTROL KNOB

    A01E0PD

    1. Remove the heater control knob as shown in the illustration.

  4. REMOVE FRE/REC CONTROL KNOB

    A01E1LV

    1. Remove the No. 2 heater control knob as shown in the illustration.

  5. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

    A01DZ1DE01

    1. Detach the 2 claws and remove the switch.