AIR FUEL RATIO SENSOR(for Sensor 1) INSTALLATION

PROCEDURE

1. INSTALL AIR FUEL RATIO SENSOR

   

   *a	Torque Wrench Fulcrum Length

   Tip:

   Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

   Click hereClick here

   1. Using SST, install the air fuel ratio sensor to the exhaust manifold converter sub-assembly.

      09224-00011

      Specified tightening torque

      44 N*m

      449 kgf*cm

      32 ft.*lbf

      Note:

      If the air fuel ratio sensor has been struck or dropped, replace it.

      Tip:

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click hereClick here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

        39 N*m (398 kgf*cm, 29 ft.*lbf)

   2. Connect the air fuel ratio sensor connector.

   3. Engage the wire harness clamp.

2. INSTALL OUTER COWL TOP PANEL

   • for LHD:

     Click hereClick hereClick hereClick here

   • for RHD:

     Click hereClick here

3. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

   • for LHD:

     Click hereClick hereClick hereClick here

   • for RHD:

     Click hereClick here

4. INSTALL WATER GUARD PLATE LH

   • for LHD:

     Click hereClick hereClick hereClick here

   • for RHD:

     Click hereClick here

5. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

   Click here

6. INSPECT FOR EXHAUST GAS LEAK

   Click hereClick here

7. PERFORM INITIALIZATION

   1. Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

      Click hereClick here