GENERATOR REMOVAL


  1. DISCONNECT NEGATIVE BATTERY CABLE

  2. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

  3. REMOVE FRONT DOOR SCUFF PLATE RH

  4. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

    Tech Tips

    Perform the same procedure as above on the opposite side. Click here

  5. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

    Tech Tips

    Perform the same procedure as above on the opposite side. Click here

  6. REMOVE ENGINE SERVICE HOLE SUB COVER ASSEMBLY


    1. Roll up the carpet, and remove the engine service hole sub cover assembly.

  7. REMOVE FENDER APRON MUDGUARD SEAL RH

  8. REMOVE FAN & GENERATOR V BELT


    1. B007VAXE03

      Remove the drive belt by rotating the tensioner pulley in clockwise direction to loosen its tension with the pulley set bolt of the tensioner.

  9. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (w/ Air Conditioning System)


    1. Disconnect the connector.

    2. B007QP1

      Remove the 4 bolts and compressor and magnetic clutch.

  10. REMOVE AIR TUBE ASSEMBLY


    1. Remove the 2 clamps, 2 bolts and air tube assembly.

  11. REMOVE AIR CLEANER HOSE ASSEMBLY


    1. Remove the bolt and air cleaner hose assembly.

  12. REMOVE VENTILATION PIPE


    1. Remove the bolt and ventilation pipe.

  13. REMOVE COMPRESSOR OUTLET ELBOW


    1. B007V5Z

      Remove the 2 bolts and 2 clamps, then remove the compressor outlet elbow.

  14. REMOVE IDLE NO.2 PULLEY ASSEMBLY (w/ Air Conditioning System)


    1. B007OD2E01

      Remove the bolt and washer, then remove the idle No.2 pulley assembly.

  15. REMOVE GENERATOR BRACKET


    1. B007Q8BE01

      Remove the 2 bolts, then remove the generator bracket.

  16. REMOVE GENERATOR ASSEMBLY


    1. B007TSLE01

      Disconnect the generator connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the wire harness from terminal B.

    4. Remove the bolt and generator assembly.