DIFFERENTIAL PRESSURE SENSOR(w/ Glow Plug Controller) INSTALLATION

PROCEDURE

  1. INSTALL DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

    1. A361094C01

      *1

      No. 1 Vacuum Transmitting Hose Assembly

      *2

      No. 2 Vacuum Transmitting Hose Assembly

      *a

      View A

      *b

      Marked Yellow

      *c

      Marked Pink

      Install the differential pressure sensor assembly to the sensor bracket with the bolt.

      11 N*m

      112 kgf*cm

      8 ft.*lbf

    2. Connect the No. 2 vacuum transmitting hose assembly to the differential pressure sensor assembly and slide the clip to secure it.

    3. Connect the No. 1 vacuum transmitting hose assembly to the differential pressure sensor assembly and slide the clip to secure it.

    4. Engage the guide to install the No. 2 wire harness heat insulator to the differential pressure sensor assembly.

    5. Return the No. 2 wire harness heat insulator and engage the snap fastener.

    6. Engage the clamp to connect the engine wire to the sensor bracket.

    7. Connect the differential pressure sensor assembly connector.

  2. INSTALL WIRE HARNESS CLAMP BRACKET

    Click here

  3. INSTALL NO. 1 WIRE HARNESS HEAT INSULATOR

    Click here

  4. INSTALL OUTER COWL TOP PANEL

  5. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

  6. INSTALL WATER GUARD PLATE LH

  7. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  8. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  9. LEARNING DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

    1. Start the engine and wait until the engine coolant temperature reaches 75°C (167°F) or more. (A)

    2. Turn the ignition switch off and wait for 30 seconds or more. (B)

    3. Repeat the above procedures (A) and (B) 3 times.

      Tip:

      • Procedures (A) and (B) must be repeated 3 times to complete the differential pressure sensor assembly learning process.

      • If the differential pressure sensor assembly learning is incomplete, DTC P244A may be stored.