STEERING PAD INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL HORN BUTTON ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

      B006BY6
    3. B006AS0C01
      *a Lock Button
      *b Wire Harness Clamp
      B006AHR Airbag Connector
      B006EC9 Horn Connector
      B006DHE Push

      Support the horn button assembly with one hand.

    4. Connect the horn connector and attach the wire harness clamp.

    5. Connect the airbag connector and push the lock button.

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to connect the connectors to each corresponding color.

      • Make sure the lock button is securely locked.

    6. Set the horn button assembly to the steering wheel assembly.

    7. Check that the airbag wire harness and horn wire harness are not pinched.

    8. B006CISC01
      *a Upper Pin
      *b Lower Pin

      Press the horn button assembly with both hands to attach the upper pin to the upper spring.

    9. Press the horn button assembly with both hands to attach the lower pin to the lower spring.

      Note

      After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.

  2. INSTALL LOWER NO. 3 STEERING WHEEL COVER

    B006AXO

    1. Attach the guide and claw to install the lower No. 3 steering wheel cover.

  3. INSTALL LOWER NO. 2 STEERING WHEEL COVER

    B006GH1

    1. Attach the guide and claw to install the lower No. 2 steering wheel cover.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  6. INSPECT HORN BUTTON ASSEMBLY


    1. Make sure that the horn sounds.

      If the horn does not sound, inspect the horn system.

      Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. CHECK SRS WARNING LIGHT

    Click here