REAR UPPER ARM INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH

    1. Temporarily install the rear upper control arm assembly LH to the rear suspension member and rear axle carrier with the 2 bolts and 2 nuts.

  2. STABILIZE SUSPENSION

    Click here

  3. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH

    1. Using a jack and wooden block, raise the vehicle so that the rear No. 2 suspension arm assembly LH is at the standard vehicle height to apply load to the rear suspension.

    2. Tighten the 2 bolts and 2 nuts of the rear upper control arm assembly LH.

      90 N*m

      918 kgf*cm

      66 ft.*lbf

      Note:

      Since a stopper nut is used, tighten the bolt.

  4. CONNECT SKID CONTROL SENSOR WIRE

    1. Connect the skid control sensor wire to the rear upper control arm assembly LH with the 2 nuts.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

  5. INSTALL REAR SUSPENSION ARM COVER LH (w/ Cover)

    Click here

  6. INSTALL REAR WHEEL

    Click here

  7. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here