ROOM LIGHT REMOVAL

PROCEDURE

1. REMOVE NO. 1 ROOM LIGHT ASSEMBLY (for Slide Switch Type)

   1. 

      *a	Protective Tape
      *b	Front

      Using a screwdriver, disengage the 4 claws to remove the No. 1 room light lens.

      Tip:

      Tape the screwdriver tip before use.

   2. 

      *a	Protective Tape
      *b	Front

      Using a screwdriver, disengage the 4 claws as shown in the illustration to separate the No. 1 room light housing.

      Tip:

      Tape the screwdriver tip before use.

   3. 

      *a	Room Light Switch Base

      Disengage the clamp.

   4. Using a screwdriver, disengage the 4 claws to disconnect the room light switch base from the No. 1 room light housing.

2. REMOVE NO. 1 ROOM LIGHT BULB (for Slide Switch Type)

   1. Remove the No. 1 room light bulb from the room light switch base.

3. REMOVE NO. 1 ROOM LIGHT ASSEMBLY (for Push Switch Type)

   1. 

      Using a moulding remover, disengage the 4 claws.

   2. Disconnect the connector to remove the No. 1 room light assembly.

4. REMOVE REAR ROOM LIGHT LENS RH (for Push Switch Type)

   1. 

      *a	Protective Tape

      Using a screwdriver, disengage the 3 claws to remove the rear room light lens RH.

      Tip:

      Tape the screwdriver tip before use.

5. REMOVE REAR ROOM LIGHT LENS LH (for Push Switch Type)

   Tip:

   Use the same procedure as for the RH side.

6. REMOVE NO. 1 ROOM LIGHT BULB (for Push Switch Type)

   1. Remove the 2 No. 1 room light bulbs from the No. 1 room light housing.