STEERING COLUMN ASSEMBLY INSPECTION

PROCEDURE

  1. INSPECT PRELOAD

    1. C302492C01

      *a

      Cloth

      *b

      Wooden Block

      Secure the steering column assembly in a vise using aluminum plates, cloths and wooden blocks.

      Note:

      Do not overtighten the vise.

    2. C303947N01

      Using SST and a torque wrench, turn the steering main shaft at a constant rate of approximately 1 revolution every 4 seconds and measure the preload.

      09616-00011

      Preload

      1.0 N*m (10 kgf*cm, 9 in.*lbf) or less

      If the preload is not as specified, replace the steering column assembly with a new one.

  2. INSPECT STEERING COLUMN ASSEMBLY

    1. C302491

      Check that the 2 bushings are securely installed to the steering column assembly.

      If the bushings are deformed, missing or damaged, replace the steering column assembly with a new one.

  3. INSPECT STEERING LOCK OPERATION (w/o Entry and Start System)

    1. Check that the steering lock mechanism is activated when the key is removed.

    2. Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.

      If there are any abnormalities, replace the ignition switch lock cylinder assembly or upper steering column bracket assembly.