KNOCK SENSOR INSTALLATION

PROCEDURE

  1. INSTALL KNOCK CONTROL SENSOR

    Tip:

    Perform "Inspection After Repair" after replacing the knock control sensor.

    Click hereClick here

    1. A354287C01

      *a

      Top

      *b

      Front of Engine

      *c

      Mark

      *d

      12.5°

      *e

      5°

      Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

      20 N*m

      204 kgf*cm

      15 ft.*lbf

      Note:

      • If the knock control sensor has been struck or dropped, replace it.

      • Make sure that the knock control sensor is in the correct position.

    2. Connect the knock control sensor connector.

    3. Install the No. 4 engine wire with the bolt.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

  2. INSTALL GENERATOR ASSEMBLY

    Click here

  3. PERFORM INITIALIZATION

    1. Perform "Inspection After Repair" after replacing the knock control sensor.

      Click hereClick here