HUMIDITY SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL RAIN SENSOR TAPE

   Tech Tips

   The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated with foreign matter.

   
   

   1. Clean the rain sensor sensing portion with a piece of cloth.

   2. 

      Rain Sensor Tape

      Peel off the smaller release sheet, and then attach the rain sensor tape to the rain sensor sensing portion as shown in the illustration.

      Tech Tips

      Use your fingers to push out any air bubbles from under the tape.

      Standard Clearance
      Area Measurement A 14.4 mm (0.567 in.) B 7.25 mm (0.285 in.)

2. INSTALL RAIN SENSOR

   
   

   1. Clean off the dirt on the windshield glass with a piece of cloth.

      Note

      
      

      • Make sure that there is no rain sensor tape residue from the removed rain sensor on the windshield glass. If there is, remove the residue.

      • If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.

      • If the rain sensor has been dropped, replace it with a new one.

   2. When installing a new rain sensor or when the rain sensor tape has been replaced:

      
      

      1. Remove the peeling paper.

         Tech Tips

         Do not directly touch the rain sensor tape surface.

   3. Connect the connector.

   4. 

      *1	Stopper
      	Install in this Direction (1)
      	Install in this Direction (2)

      Push the rain sensor in the direction (1) indicated by the arrow shown in the illustration, and gradually attach to the windshield glass surface so that air bubbles do not form between the contact surfaces.

      Tech Tips

      Do not directly touch the rain sensor tape surface and the windshield glass surface.

   5. Engage the stopper in the direction (2) indicated by the arrow shown in the illustration and install the rain sensor.

3. INSTALL RAIN SENSOR COVER

   
   

   1. 

      Attach the claw and install the rain sensor cover.