INTAKE MANIFOLD REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of throttle body assembly

  • Cleaning the deposits from the throttle body assembly

  • Gas leak from exhaust system is repaired

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

    Click here

  2. REMOVE FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY

    Click here

  3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

    Click here

  4. DISCONNECT NO. 2 VENTILATION HOSE


    1. B0087VM

      Slide the clip and disconnect the No. 2 ventilation hose from the intake manifold.

  5. REMOVE VACUUM SENSOR (MANIFOLD ABSOLUTE PRESSURE SENSOR)


    1. B008889

      Disconnect the vacuum sensor (manifold absolute pressure sensor) connector.

    2. Disconnect the vacuum hose from the intake manifold.

    3. Remove the bolt and vacuum sensor (manifold absolute pressure sensor) from the intake manifold.

  6. REMOVE PURGE VALVE (PURGE VSV)


    1. B0083LWC01
      *1 Fuel Vapor Hose
      *2 Fuel Vapor Feed Hose Assembly

      Slide the clip and disconnect the fuel vapor hose from the intake manifold.

    2. Slide the clip and disconnect the fuel vapor feed hose assembly from the purge valve (purge VSV).

    3. Disconnect the purge valve (purge VSV) connector.

    4. Remove the bolt and purge valve (purge VSV) from the intake manifold.

  7. REMOVE FUEL PUMP PROTECTOR

    Click here

  8. REMOVE NO. 2 EGR PIPE


    1. B0085T0

      Disengage the wire harness clamp from the No. 2 EGR pipe.

    2. B0086BB

      Remove the 4 bolts and No. 2 EGR pipe from the EGR valve assembly and intake manifold.

    3. B0086NV

      Remove the No. 2 EGR pipe gasket from the EGR valve assembly.

    4. B0085DW

      Remove the EGR inlet gasket from the intake manifold.

  9. DISCONNECT ENGINE WIRE


    1. B0087WX

      Disconnect the 4 connectors.

    2. B0084D9

      Disengage the 11 wire harness clamps and disconnect the engine wire.

  10. REMOVE INTAKE MANIFOLD


    1. B0084YL

      Remove the 6 bolts and intake manifold from the cylinder head sub-assembly.

    2. B0084KR

      Remove the manifold gasket from the intake manifold.