PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) Image from Camera for Parking Assist Monitor is Abnormal

DTC Code DTC Name
Image from Camera for Parking Assist Monitor is Abnormal

DESCRIPTION

The display signal from the rear television camera assembly is transmitted to the multi-display assembly via the parking assist ECU.

WIRING DIAGRAM

E282838E01

CAUTION / NOTICE / HINT

Note:

  • When "System initialising" is displayed on the parking assist ECU after the battery terminal has been disconnected, correct the steering angle neutral point (Click here).

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click hereClick here).

Tip:

  • Images may be unclear even in normal conditions if:

  • Electrical devices are used in the cabin (noise may occur in the image).

  • The camera lens is frosted over (the image immediately after turning the engine switch on (IG) may be blurred or darker than normal).

  • The camera lens is dirty with snow, mud, etc.

  • A strong beam of light, such as a sunbeam or headlight, hits the camera.

  • It is too dark around the camera (at night etc.).

  • The ambient temperature around the camera is either too high or too low.

  • The vehicle is tilted at a steep angle.

  • The rear television camera assembly lens is scratched.

  • The rear television camera assembly lens has drops of water on it or the humidity is high.

  • When the camera is used under fluorescent lights, sodium lights, or mercury lights etc., the lights and the illuminated area may appear to flicker.

PROCEDURE

  1. CHECK SIDE MONITOR SYSTEM

    1. Check if the same malfunction occurs when the side monitor screen is displayed.

    Result

    Result

    Proceed to

    Malfunction occurs when parking assist monitor screen is displayed (side monitor screen is normal).

    A

    Malfunction occurs when parking assist monitor screen and side monitor screen are displayed.

    B
    B

    CHECK HARNESS AND CONNECTOR (GVIF CABLE)Click here

    A

  2. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA ASSEMBLY AND BODY GROUND)

    Click here

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK PARKING ASSIST ECU (CB+, CGND)

    Click here

    Result

    Proceed to

    OK

    NG
    NG

    REPLACE PARKING ASSIST ECU

    Click here

    OK

  4. CHECK REAR TELEVISION CAMERA ASSEMBLY (CV+, CGND)

    Click here

    Result

    Proceed to

    OK

    NG
    NG

    REPLACE REAR TELEVISION CAMERA ASSEMBLY

    Click here

    OK

  5. CHECK HARNESS AND CONNECTOR (GVIF CABLE)

    1. Replace the GVIF cable with a normally functioning one.

    2. Check if the same malfunction recurs when the parking assist monitor screen is displayed.

      OK

      Malfunction does not reoccur (returns to normal).

    Result

    Proceed to

    OK

    NG
    OK

    END (GVIF CABLE IS DEFECTIVE)

    NG

  6. CHECK MULTI-DISPLAY ASSEMBLY

    1. Replace the multi-display assembly with a normally functioning one.

      Click here

    2. Check if the same malfunction recurs when the parking assist monitor screen is displayed.

      OK

      Malfunction does not reoccur (returns to normal).

    Result

    Proceed to

    OK

    NG
    OK

    END (MULTI-DISPLAY ASSEMBLY IS DEFECTIVE)

    NG

    REPLACE PARKING ASSIST ECU

    Click here